BetaShell Lifetime Warranty Statement

All our lens cases have a lifetime warranty against manufacturing defects. Just send the case back to us and we will repair or replace your case at no additional charge. *

* Please read below for Terms and Conditions of our Beta Shell™ Bomb-Proof Guarantee

We (the manufacturer) reserve the right to charge for return shipping costs in some situations. We reserve the right to ask for payment for repairs if product was misused or damaged beyond reasonable repair. Both the manufacture and/or distributors / retailers reserve the right to change Guarantee terms and conditions.

Beta Shell Lens cases may be deemed to be defective and qualify for repair under our lifetime warranty against manufacturing defects if a lens case does not meet the minimum criteria at new condition -

1) The lens case lid must open and close easily and smoothly. 2)The lens lid sealing member (O-ring) should be lightly oiled and smooth in appearance. 3) The lid upon closed by hand must be keep dust, dirt, and rain from entering the case. 4) When the case lid is closed correctly and tightly ( by using the leverage nubs) to a minimum torque of at 20 N-m the lens case should be water tight against full submersion under 1ft of water for a minimum of 3 minutes. 4) The external appearance of the lens case should be clean from significant manufacturing / shipping scratches. 5) The top and lower lids should have no edges that can easily injure user hands and fingers under intended use. 6) Internal memory foam parts will be clean and uniform in shape and appearance. 7) Internal neoprene liner will be adequately adhered to inside of lens case body with no significant bulges or seams to catch on stored lens. 8 ) Normal wear and tear to exterior of case (e.g. surface scratches) not affecting function of case are not covered under warranty.

Acceptable conditions that do not qualify for warranty claims are (but not limited to) the following -

1) Minor surface scuffs and tone imperfections of the surface finish of the lens case. Warranty does not cover repair of appearance wear and tear (e.g. surface scratches). 2) Machining or injection molding marks and imperfections no taller than 1mm from ambient surface. 3) Slight non-uniformity in or around the abs adhesive sealed areas of the case that does not affect lens case function. 4)Cutting marks around the perimeter of memory foam and other foam pieces. 5) Any other reasonable minor manufacturing imperfection that does not affect function of intended lens case.

We the manufacturer, or related distributors and retailers reserve the right to determine if a returned Beta Shell™ product is defective and covered under the above stated warranty. Please contact us or your local distributor prior to sending back product for a Warranty claim.




Beta Shell™ Product Liability and Disclaimer
It is your responsibility to protect your photographic equipment. The user shall determine the suitability of this product prior for his or her use, and shall assume all risk of liability in connection with that use. Under no circumstance will Mogomoto Prototype LLC be held responsible for damage to photo equipment arising from the use of this product. Neither Mogomoto Prototype LLC, it’s suppliers, subcontractors, dealers or agents are liable for any loss, injury, or damage whatsoever arising from the use of this product. Modifications to your Beta Shell™ lens case will void the warranty. Never expose to excessive heat or petroleum based solvents. Never use this lens case to carry or protect objects other than photographic equipment. Beta Shell™ cases are designed to be water-proof under test conditions. Water penetration will occur if lid is not properly closed, set, worn, or is damaged. Normal wear and tear will compromise the function of this product. Beta Shell™ lens cases are protected under U.S. patent right laws. Beta Shell™ lens cases are Patent Pending.