HT-307 is a simple DC Motor Controller which can be used to control the DC motor in both Forward or Reverse direction. User is required to stop the motor before change the direction each time.
Input Voltage: 9 -12VDC
3 Control Buttons: Forward, Reverse and Stop
Reverse Polarity Protection
Suggestion / Optional part
Recommend to use 12-15VDC Motor
Check off the components in the package against the component listing before assembly.
Start with the smallest components working up to the taller components, soldering any interconnection wires last.
Place and Solder the components into the board, make sure the components are in right position according to the overlay of PCB
Test & Adjustment
After assembled, please check & ensure the value & polarity for all components were inserted into PCB correctly, wrong polarity connection of capacitors can caused explosion of failure.
Next, ensure all these leads are soldered, no solder bridges between adjacent pads and no dry joint.
Once confirmed, connect the power source to the circuit board.
When the tact switch (SW2) is pressed, the motor will spin in forward direction.
When the tact switch (SW3) is pressed, the motor will spin in reverse direction.
When the push off switch (SW1) is pressed, the motor will stop
The motor must in stop condition before user can change the direction each time.
Package includes schematic, printed circuit board, heat sink and components except DC Motor
You need to have a soldering skill and basic knowledge of testing
For any inquiry or other technical problem, please contact us through firstname.lastname@example.org or 07-3344473
http://www.hitectrons.com Last Updated @ 8/25/2016 1:56:27 PM
Buy with confidence, we have 251 Good Ratings from buyers!
sokok ask: (2016/7/30 17:38)
Hallo...limit stop switch ada tak ..contoh motor berpusing sampai limit ia berhenti..ada stock tak...
reply: hitectrons (2016/8/4 11:02)
Hi, For your application, we recommend to use HT424 which we can change the program to suit your need, but additional charges will be imposed on. Please contact us through 07-3344473 for details, PIC: Mr. Chan. Thanks. Regards, CLWong
lolzkokpin ask: (2013/2/21 14:35)
how many watt
reply: hitectrons (2013/2/21 14:48)
the board required 9-12V, only can drive motor that below 1A. Motor is not included. if 12V, 1A then is 12W. Thank you.
You may also be interested in : dc motor
electronics diy hobby kit
electronic hobby kit
hobby Tag :
* hobi, Mudah cari di Lelong
The seller assumes all responsibility for listing this item. Please contact the seller to resolve any questions before or after purchasing the item. Currency is RM (Ringgit Malaysia) unless otherwise noted. Note :