HT-311A is a Sound Activated Switch which can be used to turn the devices on and off when a loud sound was detected twice such as clapping your hands twice.
Check off the components in the package against the component listing before assembly.
Start with the smallest components working up to the taller components, soldering any interconnection wires last.
Place and Solder the components into the board, make sure the components are in right position according to the overlay of PCB
Test & Adjustment
After assembled, please check & ensure the value & polarity for all components were inserted into PCB correctly, wrong polarity connection of capacitors can caused explosion of failure.
Next, ensure all these leads are soldered, no solder bridges between adjacent pads and no dry joint.
Once confirmed, connect the power source to the circuit board.
If all goes well, this kit starts function as following:
When user claps the hand twice, t he r elay coil will be energized to enable the output. Also, the Red LED indicator on the PCB will turn on.
When user claps the hand twice again, the relay coil will be de-energized to disable the output and the RED LED indicator will turn off.
Adjust the preset (P1) for the sensitivity of sound activated switch.
Package includes schematic, printed circuit board and components
You need to have a soldering skill and basic knowledge of testing
For any inquiry or other technical problem, please contact us through firstname.lastname@example.org or 07-3344473
Last Updated @ 1/6/2016 10:14:08 AM
Buy with confidence, we have 251 Good Ratings from buyers!
You may also be interested in : sound activated
sound activated switch
electronics diy hobby kit
switch Tag :
* bertepuk tangan, * bertukar
The seller assumes all responsibility for listing this item. Please contact the seller to resolve any questions before or after purchasing the item. Currency is RM (Ringgit Malaysia) unless otherwise noted. Note :