L298N DC Stepper Motor Driver Controller Board Module for Arduino
Using L298N as the control chip, the module has such characteristics as
Having 15 pins as package, this chip has such features as high working voltage (maximum voltage up to 46V), large output current (instantaneous peak current up to 3A,continuous working current 2A) and 25W of rated power. Two built-in H bridge high voltage and large current full bridge drivers can be used to drive the DC motor and stepper motor, relay coil and so on. Using standard logic level signal control, it has two enable control ends. It permits or prohibits device having a logic power supply input without the impact of input signal, which enables the internal logic circuit part works at low voltage. The chip can connects to external detecting resistor to give the variations to the control circuit. Using L298N chip to drive the motor, this chip can drive a stepping motor or four phase stepping motor, and two DC motors as wellstrong driving
Ability: low calorific value and strong anti-interference ability.
Built-in 78M05,get power from drive power, however, when drive power over12V, please use the external 5v power as power supply.
Large capacity filter capacitance, after flow protection diode, more stable and reliable
Note : The seller assumes all responsibility for listing this item. Please contact the seller to resolve any questions before or after purchasing the item. Currency is RM (Ringgit Malaysia) unless otherwise noted.