Sleeping mode in synchronization with PC's power
One button for RAID mode control
Support HDD Hot-Swappable
Smart Fan functions
Multi-function LED displays
External power supply
10 Times Faster
The full-duplex data transfers capability allows the sending and receiving of data (at the same time) at 10 times faster than an equivalent card of USB 2.0 Standard. The maximum speed of USB 3.0 is 5Gbps, which enables the data transfer up to 25GB within a minute.
Sleeping mode in synchronization with PC's power.
FORCED CONVECTION PROCESS Known for it's exceptional properties for being lightweight, high rigidity and superior heat dissipation capabilities, Aluminum is an obvious choice when it comes to constructing a quality hard drive enclosure, especially with the excess heat generated from the high-speed hard drives available in the market.
HDD X 4 (Supported)
All 4 HDDs are recognized when they are installed.
Comes with auto / manual modes & 3 levels of
speed for best convention.
Smart Fan functions: Thermal-sensor built-inAuto & manual modes3 levels of speed
Fan easy to install & dismantle
You can change the fan with another identical fan.
Spanning Mode Spanning concatenates multiple hard drives as a single large volume;resulting in a seamless expansion of virtual volumes beyond the physical limitations of singularly connected hard drives
Striping Mode Striping is a method of concatenating multiple hard drives into one logical storage unit. It is the automated
process of writing data across multiple drives simultaneously. Striping is used to increase the performance of disk reads. The multiple hard drives will write data in “column” effect. If one drive in a striped set fails, all of the data in the stripe set is lost.
Mirroring Mode Mirroring is the automated process of writing data to multiple drives simultaneously. Mirroring is used to provide redundancy.
If one drive fails, the redundant drive(s) will continue to store the data and provide access to it. The failed drive can then be
replaced and the drive set
can be re-mirrored.
Striped set with dedicated parity This mechanism provides an improved performance and fault tolerance similar to RAID 5 but with a dedicated parity disk rather than rotated parity stripes. The single parity disk is a bottle-neck for writing since every write requires updating the parity data. One minor benefit is the dedicated parity disk allows the parity drive to fail and operation will continue without parity or performance penalty.
RAID O - Spanning Mode Striped set with distributed parity Distributed parity requires all drives but one to be present to operate; drive failure requires replacement, but the array is not destroyed by a single drive failure. Upon drive failure, any subsequent reads can be calculated from the distributed parity such that the drive failure is masked from the end user. The array will have data loss in the event of a second drive failure and is vulnerable until the data that was on the failed drive
is rebuilt onto a replacement drive.
RAID 1 + 0 RAID 1+0 is mirrored(Raid 1) sets in a striped(Raid 0) set .
Specifications / Warranty
1-Year Warranty by HOTWAY
Buy with confidence, we have 1890 Good Ratings from buyers!
It was good that i receive a call about item being out of stock and informed about the delay. Too bad the courier company held my item for a couple of days for no reason.
Note : The seller assumes all responsibility for listing this item. Please contact the seller to resolve any questions before or after purchasing the item. Currency is RM (Ringgit Malaysia) unless otherwise noted.