Adding an amplifier is the cheapest way to increase your picture, sound, and overall signal quality significantly! Installation in under 15 seconds. Look at the screen shot above and see how much our amplifier clears up static and picture quality. Works on all cable TV and satellite providers. Great addition for powered antennas too.

New Inline Amplifiers

This is the high quality amplifier BOOST UP TO 30 dB and cover any 40-2400 MHz ranges.

Great for boosting satellite signal and improve switch functionality, if your system setup is suffering from long run cabling;

Improving  the strenghth of Siganal so that yout satellite TV/Astro less affected by the rain

• Compatible with all Satellite systems.

DON'T WASTE YOUR MONEY ON EXPENSIVE AMPLIFIERS THAT DO LESS, OUR PRODUCT IS ALL YOU'LL NEED.

Designed for inline boosting of weak signals. Powered through the existing coaxial run (no power cable is needed). Deluxe zinc alloy housing with silicon sealant makes perfect for indoor/outdoor use. Water and weather resistant, will not rust. Works with all RG6/RG59 coaxial cables and more!  

If you have coaxial cable runs longer than 20 feet, or if you have split your signal multiple times, you must add a signal amplifier to compensate for signal losses. Our product uses premium-grade electronics for the strongest, cleanest signal with maximum gain and ultra-low noise. You get wideband frequency response and true 75 ohm impedance.

Delivers the best possible signal quality for:

·        All satellite systems including all free to air

·        Cable internet and TV

·        Broadcast TV or HDTV