high power Vibration sensor,easy vibration sensor,simple vibration sensor,1527,433/315,shock sensor, For home alarm panel
High power design, far distance, low power indicated, widely used for monitoring vibration, with high reliability, small size, easy installation and strong flexibility. Once vibration is detected, it will be triggered and immediately sends out wireless signal to main alarm system to warning. Installing place:special for bank safe box and others
Working voltage:12V DC, with dry battery model:23A . Low battery voltage about 8V.
Working current:about 50mA Static current:5uA
Power: standby :0.01W, Alarm :0.09W
Working frequency:433.92 MHZ or 315 MHZ, other RF to be ordered
Transmitting distance: noninterference about 300m ; indoor about 50~100 m
Emitting frequency:about 10mw
Chip: EV1527 resistor 330k
Oscillator resistor can be changed by jumper: 1.5ohm/3.3ohm/4.7ohm selectable.
Operating temperature: indoor -10 -50C, related humidity lower than 90%
Size: Transmitter part: 90 mm(L)x 55 mm(W) x 22 mm(H)
Code preset by factory. If not, please follow the following code diagram to play it by clamp or by hand; Zone Code Jumper: A0-A7 is address code correspond with alarm host.D0-D3 is data code for setting different zone. Note: H=1, L=2, Empty =0. If the control panel doesn’t need to preset code,please follow the instruction to log in this transmitter.
Fix it on the wall,plastic window,drawer,cabinet and protected object by stick paper or screw.
The signal red LED flash for 1 second to alarm,The low battery green LED lights all along which means batter power is not enough. Please replace the same size new battery
Note : The seller assumes all responsibility for listing this item. Please contact the seller to resolve any questions before or after purchasing the item. Currency is RM (Ringgit Malaysia) unless otherwise noted.