12V Water Pump, Power of 30w, Pressure Switch, Self-Priming

Features:

Diaphragm pumps

Self-priming

Automatic pressure switch

Electric Power

Corrosion resistance

Non-Submersible

Specifications:

Suction lift: 1.5m

Outlet pressure: 0.7MPa

lift: 60m

Flow: 180L/H

Noise: 60-70dB

Motor lifespan: 3-5years

Applications:

Booster pumps, car wash pumps, garden watering pumps, etc.

Special Instruction:

1. About Automatic pressure switch: When the water is turned off, the power supply will be automatically cut off, and the motor will stop working. When the water is turned on, the power will be automatically turned on, and the motor will start to work.

2. Make sure the connection between pump and pipe is closely, otherwise the pressure will be very low.

3. Use clean water, and install a filter in the inlet. The water temperature should not exceed 60 degrees.

4. This is a non-submersible water pump, do not let water into the motor part. Do not let the water pump placed in a damp place for a long time.

5. Try not to work continuously to prevent the temperature is too high burning motor.

6. Inlet pipe: the shorter the better, the thicker the better, the water pressure can not exceed 0.2MPa. If pump was directly connected with the pressure water, should extend the inlet pipe.

7. When in the winter, drain the water completely, to prevent the pump be frozen..

8. When not in use for long periods of time, disconnect the power.

9. Cherish your water pump.

10. Do not disassemble.