8 channel relay opto-isolated 5V 10A Relay Module for Arduino

8 channel 5V relay board for Arduino Demo.

Connect VCC to 5V, GND to Ground, COM to 5V or 3.3V, IN1 to Digital 6 ... IN 4 to Digital 8

---------------------------------------------------------

#define RELAY1 6

#define RELAY2 7

#define RELAY3 8

#define RELAY4 9

void setup()

{

// Initialise the Arduino data pins for OUTPUT

pinMode(RELAY1, OUTPUT);

pinMode(RELAY2, OUTPUT);

pinMode(RELAY3, OUTPUT);

pinMode(RELAY4, OUTPUT);

}

void loop()

{

digitalWrite(RELAY1,LOW); // Turns ON Relays 1

delay(2000); // Wait 2 seconds

digitalWrite(RELAY1,HIGH); // Turns Relay Off

digitalWrite(RELAY2,LOW); // Turns ON Relays 2

delay(2000); // Wait 2 seconds

digitalWrite(RELAY2,HIGH); // Turns Relay Off

digitalWrite(RELAY3,LOW); // Turns ON Relays 3

delay(2000); // Wait 2 seconds

digitalWrite(RELAY3,HIGH); // Turns Relay Off

digitalWrite(RELAY4,LOW); // Turns ON Relays 4

delay(2000); // Wait 2 seconds

digitalWrite(RELAY4,HIGH); // Turns Relay Off

}

-----------------------------------------------------------------

1. With An onboard EL817 optocouplers, optical isolation has strong anti-jamming capability

2, On board 5V, 10A / 250VAC, 10A / 30VDC relay, relay life span continuous pull 100,000 times

3, The module can be directly link to microcontroller I/O port, with an output signal indicator

4, the module has a freewheeling diode protection, short response time

5, PCB Dimensions: 79.5 (mm) x71 (mm)