Arduino Double VNH2SP30 30A Stepper Motor Driver Monster Moto module

This is essentially a ramped up version of Ardumoto motor driver shield. For this monster shield we've replaced the L298 H-bridge with a pair of VNH2SP30 full-bridge motor drivers. We've also beefed up the support circuitry so this board is capable of driving a pair of high-current motors! The VIN and motor out are pitched for our 5mm screw terminals (not included), making it easy to connect larger gauge wires.       
      
      Note:When using this board in extreme high-demand applications it may be necessary to improve thermal performance with a heat-sink or fan and to solder the wires directly to the board instead of using a screw terminal (in addition to the myriad other complications present in a high-current system) However, when using the board at currents up to 6A the chips will barely become noticeably warm.       
      
      Features:       
      
      Voltage max: 16V       
      Maximum current rating: 30 A       
      Practical Continuous Current: 14 A       
      Current sensing available to analog pin       
      MOSFET on-resistance: 19 mΩ (per leg)       
      Maximum PWM frequency: 20 kHz       
      Thermal Shutdown       
      Undervoltage and Overvoltage shutdown