This is LilyPad Arduino - the main board consisting of an ATmega328 with the Arduino bootloader and a minimum number of external components to keep it as small (and as simple) as possible. Board will run 5V. The latest version of the LilyPad supports automatic reset for even easier programming. The back side of the LilyPad is now completely flat! We now use a surface mount programming connector to keep the header from poking through.
This version of the LilyPad now uses the new ATmega328 at 16MHz. Arduino 0016 supports the Arduino Pro Mini 328/16MHz. Use this setting when using this new LilyPad 328.
LilyPad is a wearable e-textile technology developed by Leah Buechley and cooperatively designed by Leah and SparkFun. Each LilyPad was creatively designed to have large connecting pads to allow them to be sewn into clothing. Various input, output, power, and sensor boards are available. They’re even washable!
Digital I/O Pins
14 (of which 6 provide PWM output)
Analog Input Pins
DC Current per I/O Pin
16 KB (of which 2 KB used by bootloader)
Note: To program the LilyPad, we will need to connect it through CP2102 Module/ FTDI. You can get it from http://www.lelong.com.my/cp2102-module-free-dupont-jumper-wire-littlecraft-158561446-2015-12-Sale-P.htm
Questions & AnswersDo you have any questions to ask merchant about this productAsk Seller
0.0 stars out of 5
Share your thoughts with others
Write a review
Only buyers who purchased the product may leave a review
Note : The seller assumes all responsibility for listing this item. Please contact the seller to resolve any questions before or after purchasing the item. Currency is RM (Ringgit Malaysia) unless otherwise noted.