BREADBOARD TERMINAL STRIPS 300 tie in points (8.3 X 3.5CM)
Here's a breadboard without power tails.With a total of 300 tie in points, all pins are spaced by a standard 0.1". This board also has a self-adhesive on the back. And it has interlocking parts which will help you hook as many together as you'd like.Moreover, it's compatible with 8.3cm x 1cm power tails.
Bus and terminal strips
Solderless breadboards are available from several different manufacturers, but most share a similar layout. The layout of a typical solderless breadboard is made up from two types of areas, called strips. Strips consist of interconnected electrical terminals.
The main areas, to hold most of the electronic components. In the middle of a terminal strip of a breadboard, one typically finds a notch running in parallel to the long side. The notch is to mark the centerline of the terminal strip and provides limited airflow (cooling) to DIP ICs straddling the centerline. The clips on the right and left of the notch are each connected in a radial way; typically five clips (i.e., beneath five holes) in a row on each side of the notch are electrically connected. The five clip columns on the left of the notch are often marked as A, B, C, D, and E, while the ones on the right are marked F, G, H, I and J. When a "skinny" Dual In-line Pin package (DIP) integrated circuit (such as a typical DIP-14 or DIP-16, which have a 0.3 inch separation between the pin rows) is plugged into a breadboard, the pins of one side of the chip are supposed to go into column E while the pins of the other side go into column F on the other side of the notch.
To provide power to the electronic components. A bus strip usually contains two columns: one for ground and one for a supply voltage. However, some breadboards only provide a single-column power distributions bus strip on each long side. Typically the column intended for a supply voltage is marked in red, while the column for ground is marked in blue or black. Some manufacturers connect all terminals in a column. Others just connect groups of, for example, 25 consecutive terminals in a column. The latter design provides a circuit designer with some more control over crosstalk (inductively coupled noise) on the power supply bus. Often the groups in a bus strip are indicated by gaps in the color marking. Bus strips typically run down one or both sides of a terminal strip or between terminal strips. On large breadboards additional bus strips can often be found on the top and bottom of terminal strips.
Breadboard Size : 8.3cm x 3.5cm
Breadboard Color Transparent
Last Updated @ 6/11/2015 4:01:46 PM
|Tz****||Breadboard Terminal Strips 300 tie in points (8.3 X 3.5CM)||
Questions & Answers Ask Seller
Bank in to our CIMB bank account and send to us the bank in slip.
We ship via PosLaju, and charge a flat rate of RM8 (RM12 for east Malaysia) for unlimited number of items per order unless otherwise stated.
Usually reach the destination within 1-2 days after shipping.
Questions & AnswersDo you have any questions to ask merchant about this product Ask Seller
0.0 stars out of 5