Any Car Headlight Restoration Kit - Headlamp Repair Renovation Restore

FULL SET SAME AS PHOTO..

v

??????????????

??????????????????

????????????????

???????????????

??????????????

??????????????

????????:

  1???????????????????320#???????10????????????????????400#?600#????5?????800#?1000#?????????????????????????????????????????????????????????????????????

   2??????????,??????????????????????????????????????????????????????????????????????????????????????????,???,????,??????????.

   3?????????????????80?100??????????????????????????????????????????????????????5?6????????????????????????????????????????????????????2?3????????????????????????

   4?????????4?5?????????????0.1?0.4????????????????

   5????????????????,??????????????????????????????????,????????,??????????????,??????

PLASE TAKE NOTE NEED TO POLISH (WITH SAND PAPER BEFORE COATING)!!!!

ESTIMATES CAN COATING 8-13 CARS

  1, (polished add some water mill up more easily) when grinding with 320 # sandpaper with point force rough grinding for 10 minutes, the old yellow trace and crack completely worn, and then were 400 #, 600 # sandpaper grinding 5 minutes And then use 800 # or 1000 # sand paper fine grinding for a while, after grinding with a dry cloth to dry the water on the headlamps carefully check whether the uniformity of sandpaper traces of uniform thickness, the best can be used before the atomizer polishing lamp Drying surface heating effect is better, faster.

   2, spray straight before the trachea straight, so that the nozzle up, because the hot fog hit the cold wall will form a water droplet, the nozzle will drop the droplets on the lamp will affect the effect of atomized cups to spray If the place has been transparent that can not be repeated many times, like fuel injection, pay attention to uniform thickness, speed and coordination. After spraying ten minutes to dry, non-stick dust, but can not scratch, let it natural curing after a few hours.

   3, each time into the atomization cup of the best amount of atomizing agent between 80 to 100 ml, in order to prevent the fog cup dry, run out of available atomizer paper cups and then back up Glass bottles for the next re-use. Mist blowout time is usually heated after 5 to 6 minutes, when the mist is often not see the spray, the time one can atomize the polishing operation, to prevent waste. Two lights atomization work as much as possible to control in 2 to 3 minutes to complete, and more spray to a long time to dry and hard and prone to light wire.

   4, the thickness of the headlamps generally between 4 to 5 mm, the crack layer depth is usually 0.1 to 0.4 mm or so, so fine grinding more than a few times and no defense.