|
EP™ Waterproofing System permanently waterproofs and preserves concrete, brick, block and all masonry surfaces & structures in one easy application.
EP™ Waterproofing System is manufactured using liquid polymers, creating a liquid nano-waterproofing material.
EP™ Waterproofing System is an excellent waterproofing product for all jobs because it cures, hardens, protects and waterproofs in one application.
EP™ Waterproofing System is non- toxic, non-flammable and non-caustic.
EP™ Waterproofing System doesn’t need to be mixed; it’s easy to use and has no solvents inside* so no bad smells and everything can be washed clean with water.
Theoretical Coverage: One (1) litre covers between 4 - 6 square metres.
Application Method: Brush, broom or low pressure spray unit (backpack type)
* Rain water is harvested from our neighbor’s roof for manufacturing EP™ Waterproofing products.
APPLICATION INSTRUCTIONS
1. Apply EP™ Waterproofing System to any dry concrete or masonry surface. Test in a small area before any application.
2. Use a low-pressure sprayer - back-pack type - or brush roll on.
3. Treat entire surface area using approximately 1 litre per 3– 6 square metres (32 – 64 square foot). On site product coverage can change depending on the material being treated. 4 square metres per one litre is about the average.
EP™ Waterproofing System is best applied by spray method; this is not only fast and effective but will give you an average application rate.
EPWPS will surface dry within 1 hour and be traffic ready in 5 hours. For water pond testing – wait 36 hours for standard wet areas. For commercial R.C watertanks they will need a full curing time of 5 days before filling with water for pond/water-tight testing.
Allow to dry completely prior to the application of paints or coating.
E P™ Waterproofing System will not harm glass, tile or aluminium.
Penetrates into concrete – EPWPS it NOT a surface coating
Cannot be damaged, torn or broken – unlike membranes or surface coatings.
Completely waterproofs all masonry in one application (except aerated blocks of course)
EPWPS be painted over with any coating or material i.e. floor coverings, paints, epoxy, P.U membranes
Leaves no shine, no gloss and is completely transparent which makes it excellent for facades like face brick, natural stone and most masonry
EPWPS is not a silane/siloxane sealer. No liquid glass
EPWPS will stop efflorescence by stopping water penetration
One product is for all commercial waterproofing – below ground, roof slabs, water tanks, swimming pools, wet areas and car parks
EPWPS can be used for repair of leaking bathrooms and wet areas without the need for hacking of the tiles
EP™ Waterproofing System fills the void within the cement and the various aggregates and pores, creating a polymer layer inside the concrete – waterproofing to the core.
Contact EP™ for detailed International standards on this product.
Last Updated @ 3/3/2020 10:34:58 AM
Last Updated @ 26/9/2023 9:40:19 AM
|
