|
Specifications:
KVR16LS11/4
4GB 1Rx8 512M x 64-Bit PC3L-12800
CL11 204-Pin SODIMM
Kingston Laptop DDR3L RAM 1600Mhz 4GB
This document describes ValueRAM's 512M x 64-bit (4GB) DDR3L-1600 CL11
SDRAM (Synchronous DRAM), 1Rx8, low voltage, memory module, based on
eight 512M x 8-bit FBGA components. The SPD is programmed to JEDEC
standard latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V.
This 204-pin SODIMM uses gold contact fingers.
The electrical and mechanical specifications are as follows:
• JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power Supply
• VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]
• Bi-directional Differential Data Strobe • Internal(self) calibration : Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB: Height 1.18” (30mm), double sided component
SPECIFICATIONS
CL(IDD) 11 cycles
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 35ns (min.)
Power (Operating) (1.35V) = 2.376 W*
UL Rating 94 V - 0
Operating Temperature 0 to 85 degree celcius
Storage Temperature -55 to +100 degree celcius
100% manufactured from KINGSTON, Lifetime Warranty from KINGSTON!
|
