-
-
-
-
-
-
-
-
|
This is an antenna analyzer for ham radio hobbyists. It can measure 50 ohms source impedance. It is also a meter for measuring SWR, impedance, capacitance... Features: Test the antenna technical parameters. Can test the standing wave, impedance, capacitance and so on. Frequency generation & control: 1-60MHz. External power supply: 2.1mm power jack(center pin positive). 6 operation buttons, easy and convenient to operate. Installed black metal case, just connect the power(not included) and then work. Step size: user configurable increments of 100Hz, 1KHz, 10KHz, and 100KHz. Support measuring data waveform analysis via connecting computer with USB cable(not included). Instrument Capabilities: Measure antenna electrical parameters: SWR, impedance(resistance+reactance), capacitance, inductance; Measure feed point impedance; Measure ground loss; Adjust antenna tuners and determine loss; Measure inductors and capacitors; Measure coax transmission line(SWR, length, velocity factor, approximate Q and loss, resonant frequency, and impedance); Measure and determine optimum settings for tuning stubs: SWR, approximate Q, resonant frequency, bandwidth, impedance; Determine characteristic impedance of transmission line; Determine length of \u00bc and \u00bd wave phasing lines; Coaxial Cable Loss; Determine antenna tuner loss; Measure balun loss; Measure inductor Q; Estimate quartz crystal parameters; Specifications: Version Type: Ordinary Version / Bluetooth Version(Optional) Frequency Generation & Control: 1-60MHz Source Impedance: 50 ohms Stability: (+/-) 100 ppm Spectral Purity: Harmonics Down >- TBD dB beyond 60MHz Step Size: User configurable increments of 100Hz, 1KHz, 10KHz, and 100KHz Usable Measurement Range: SWR: 1.0 to 9.99 Impedance: Approx. 5 to 2000 ohms RF Output: Adjustable: 2.0 Volts pp (typ) RF Out: BNC Power Supply: Internal: 8*AAA 1000mAh Ni-MH Cells(NOT Included); External: DC 13.8~18V, 500mA Power Requests: Internal-positive, External-negative 12V - Can drive the Analyzer to work, but can not charge the battery 13.8V~18V - Can drive the Analyzer to work, also able to charge the battery USB Interface: Mini-B Receptacle External Power Interface: 2.1mm Power Jack(center pin positive) Item Size: 100 * 85 * 38mm / 3.94 * 3.35 * 1.5in Item Weight: 254g / 8.97oz Package Size: 15 * 14 * 5cm / 5.9 * 5.5 * 1.97in Package Weight: 299g / 10.53oz Note: Power supply is not included in the package. You need to buy it by yourself. Bluetooth Version supports for Android 2.2-4.0 or new version; supports 3-10 inch mobile phone and tablet; supports for windows via software. Package List: 1 * Antenna Analyzer |
| 5 star |
|
0 |
| 4 star |
|
0 |
| 3 star |
|
0 |
| 2 star |
|
0 |
| 1 star |
|
0 |
