Photography is all about lighting. But Flashguns sometimes can be very confusing, so we have an excellent solutions for all the lighting problems. The latest Octopus OC-AT60 LCD Display GN60 TTL Speedlite is the simply solutions for creative lighting effect or Low Light condition, This Flash can be bounce and swivel. This Speedlite can use TTL mode or use as a manual flash. This flash comes with Custom Function Mode, Zoomable range from 24-105mm, M Mode, TTL Mode. It also comes with fast lock with Dust and Water Resistant hot shoe. PC Sync Cord and External Battery Power Pack also is two of the extra feature on this flash. This speedlite flash are using the latest technology (USRS) Ultra Silent Recharging system.
1. Power Management
(1)Switch to the ON, the flash will start charging (the charging indicator is dim). After several seconds, the charging indicator turns red and the flash is ready to shoot.
(2) For a test flash, press the pilot button. After use, switching off using the ON/OFF to OFF level switch the power off.
(3)If the red charging indicator lamp flickers in every 1s, it indicates low battery. In such case, the power will turn off automatically and you need to replace the batteries.
2. Power Control
(1)The flash unit has 8 steps of power output control, which indicated by the LCD Display. This speedlite flash are using the latest technology (USRS) Ultra Silent Recharging system.
(2)The flash power range from 1/128, 1/64, 1/32, 1/16, 1/8, 1/4, 1/2, 1/1.
3. M Mode
When using M Mode. You can set the flash On to your camera hotshoe or speedlite trigger hot shoe to trigger the flash unit. When shooting, adjust the flash power and press the camera shutter, the flashlight will flash under the camera synchronous signal.
4. Protection Function
(1)Protection in continuous flashes
To prevent the flash head from getting too hot and damage, please do not flash over 20
times when in power lever 1/2,1/1. Please cool down the flash unit for at least 10
minutes.The over-temperature protection function will be activated if you continue to flash after 20 times. In this state the charging time will turn to 10-25s. Please cool down the flash unit around 10 minutes and it will turn to normal state.
(2) Systematic over-temperature protection
When the inner circuit is over-heating, which indicates over use of the flash unit, the inner
circuit will shut down power automatically. The flash unit will turn to normal state after the
inner circuit is cooled down.
- Guide Number: GN60 (ISO 100)
- Flash Mode: (ETTL, ETTL II For Canon), (i-TTL For Nikon) Manual, Rear Curtain Sync.
- Vertical Rotation Angle: 0-90 Degrees
- Horizontal Rotation Angle: 0-270 Degrees
- Power: 4pcs AA Batteries (Alkaline/NI-MH)
- Duration: 100-1500 times (Depends on Flash mode)
- Output Control: 1/3 stop increment
- Sync Speed: 1/250sec. (Some Camera model maybe higher or lower)