-
Whatsapp us 019-4764 2 43
-
Enjoy 10% - 40% discount for pre-order
Description
-
1. Analyze and judge the status of oil and equipment to provide maintenance recommendations.
-
2. Oil quality test helps guard oil quality for both supply and demand, ensure the oil safety.
-
3. Lubricants and new oil quality test help customers check and accept, prevent misuse of all kinds of unqualified and fake lubricants.
How to use
-
1. Flat the instrument. First choose the gas or diesel button (GAS: gasoline: DSL: diesel),after that, pressing the power button (ON), wait 5 seconds to see the green and red light on , then drip to the test tank. Finally press the test key (TEST) to start the test
-
Note: If only #10 light is on, you need to replace the battery. If the #7.8.9 lights flash alternately, the sensor is dirty, turn off the power and clean the sensor
-
2. Add a few drops test oil on the sensor, do not let the oil surface go beyond the test slot
-
Note: In order to obtain the best test result, the temperature had better been controlled in the range of 15-27 ° C
-
3. Press the (TEST) key and release it quickly, the 10 lights will flash in sequence, and the last light will indicate the quality of the oil
-
4. Test result description
-
#1to #7,any one flash green oil quality excellent or good
-
#8 or #9 flash yellow oil quality ordinary
-
#10 flash red slowly Suggest to replace the oil
-
#10 flash red quickly Suggest to detect the engine.
-
5. When finished, press OFF
-
6. After use,cleaning test slot,cleaning and drying the sensor is very important
Calibration method
-
1. Wipe the test slot, clean and place it on a smooth platform. Press the TEST key to start, about 1 second later,#6 LED flashes, enter the calibration mode.
-
2. Release the button, about 5 seconds later, LED1 (green), LED6 (green) alternately flashes, indicating that the instrument is entering into the calibration process.
-
3. Add the sample engine oil to the test slot and press the TEST button once. (Note that the liquid surface and groove edge level, and the middle of the liquid no obvious depression.)
-
4. Wait about 5 seconds, LED1 ~ LED6 will be on circularly, calibration is successful.
-
5. Turn off the power and wipe the test slot.
-
Note: a.Complete whole process as soon as possible, in a short time (1 minute) is better , or it will easily affect the calibration results.
-
b. If the results of calibration and verification are often deviated, the reasons need to be analyzed. The result of the deviation may be
-
(1) The test slot is not wiped clean;
-
(2) Not finished within 1 minute after the start;
-
(3) Temperature, humidity is not stable;
-
(4) The amount of oil is inconsistent
Included
-
1 x OTO300 Motor Engine Oil Tester for Trucks Tractors Boats Car Engine
Shipping & Warranty
About Us
-
We Are Verified Member With I.C Submitted to Website Admin. Have Confident With Us.
-
If You Have Any Question Please Email Us :
-
Our email address on the picture
-
Free Of Charge Consulation
-
Thanks
|