Passive PoE Cable 1 Set DC 5.5 2.1mm 12V 9V 5V

Passive PoE Cable Set DC 5.5*2.1mm 12V 9V 5V

Integrating Ethernet support into your project is a great way to relay data through a local area network and even bounce information out to the internet. Sometimes it's hard to get power to your Ethernet devices. Wouldn't it be convenient to use the same cable for power and data? Using these power over Ethernet adapters, you can do just that!

The Passive PoE Cable Set comprises two cables, each cable has a female RJ45 on one side which is adapted to a male RJ45 and 5.5x2.1mm barrel jack connector on the other side. The 'injector' cable has a female barrel jack connector and the 'splitter' cable has a male barrel jack. Simply attach the cables at each end of your network cable, plug the male barrel jack from the splitter into your target device and plug your desired power adapter into the injector. Now you can use one cable to provide both power and data for your Ethernet enabled device.

These cables follow the generally accepted passive PoE standard of putting ground on pins 7&8 and power on 4&5.

POE PIN = 45?+? 78?-?+ LAN Data ?1236?

Note: You are getting a set of two cables.

Documents for Passive PoE Cable Set