VW Golf IV & Audi A3 Rear Bush Installation Tool (4649)

VW Golf IV & Audi A3 Rear Bush Installation Tool (4649)

• Condition: New
• Special designed for replacing the rear axle mounting bushes, whilst in situ on the vehicle
  and without the need for removing the rear axle assembly.
• it's fine thread and thrust bearing allows the bush to be fitted quickly and easily without causing damage.
• Use with ratchet wrench or spanner to insert composite bushes.
• Application: Audi (Audi) A3; Volkswagen (Volkswagen) Golf IV / Bora 1,4 1,6 / 1,8 / 2,0 and 1,9d (produced in 2001 or later)

Due to a difference in material and composition it is recommended when replacing these bushes that both sides are replaced at the same time. This will ensure that wheel alignment and tyre wear problems are avoided.

• Instructions
• 1. Securely support the vehicle and remove the rear wheels as specified in your workshop manual
• 2. Remove both front mounting bolts from the rear axle mounting bracket
• 3. Pull the front end of the trailing arm down the mounting bracket and wedge into position, using a solid object between the arm end and the underside of the vehicle.
• 4. Note the exact position in the arm of the rubber mounting
• 5. Remove the old mounting bush from the trailing arm
• 6. Lubricate the screw threads of the too (D)
• 7. Align the Y mark on the new bush with the mark on the axle trailing arm
• 8. Assemble the tool as shown and insert the new bonded mounting into position (see Fig 2) (ITEM B HAS A LIP THAT SITS FLUSH AGAINST THE TRAILING ARM (Z)
• 9. With a 24mm tool, slowly turn the thrust bearing (C) to pull the new mounting into the rear axle.
• 10. Re-assemble in accordance with your workshop manual
• Repeat steps 3-9 for the other side.

(C-LYN)UACQVHDCVHDC2.3KGVHBDCHBQKYN